Chippers For Sale

2021 Vermeer BC1500 Brush Chipper. Hour meter reads 246 hours. 15" chipping capacity, 3 knife. Cummins 3.8L diesel engine. Contact Erik @ Red Pine Equipment 218-720-0933. Equipment is located in Southwest USA.

1985 Trelan DL-18 Whole Tree Chipper. This equipment has a CAT 3406A engine, strong hydraulics, decent cylinders. tight disc bearing, new belts, couple sets of knives. Hood 7000 loader. Infeed and drive chain are in good working order. Contact Erik @ Red Pine Equipment 218-720-0933. Machine is located in northcentral USA.

1992 Precision Husky Chipper. Hours are unknown. KT 600 HP engine starts and runs good. New batteries, oversized cables, master switch, oversized starter, pockets, knife clamps, and counter knives, digital volt meter, and re-cored radiator within the last year. New bearings in feed rear feed wheel, a few new sprockets, drive chains, drive motors for the top feed wheel, rebuilt injector pump, and new hydraulic pump belts within the last 8 months. Also has a new shaft and bearings on the bottom feed wheel. 23" throat. Will fill 42 ton in 30-40 minutes depending on the wood. Contact Erik @ Red Pine Equipment 218-720-0933. Equipment is located in Northeast USA.

Morbark Model 16 Disc Chipper. Hour meter reads 3,500 hours. CAT 3208 engine starts and runs good. Loader with cab. Loader has a rotator for grapple installed with additional pedal. Two chutes included, one for piles and one to load trucks. Contact Aaron @ Red Pine Equipment 218-720-0933. Equipment is located in Northeast USA.

2011 Rayco RG1220 Brush Chipper. Hour meter reads 225 hours. Kubota 66.8 HP engine starts and runs good. Pre-emission engine. 12" chipping capacity with a 12"x20" in-feed opening. Intake rate of 100 fpm. Discharge swivels 360° and at a discharge height of 112". Feed wheel lift and crush handles on both sides. New battery. Contact Erik @ Red Pine Equipment 218-720-0933. Equipment is located in Northeast USA.